Notes in the operation of powder material transport vehicle

- Dec 28, 2019-

Powder material transport vehicle is an important special vehicle for transporting powder and particle materials. It is mainly used in cement plants, cement warehouses and large construction sites. Its use saves a lot of packaging materials and loading and unloading labor, and also avoids environmental pollution. What are the notes in using it?

 

1. During the driving process, the powder material transport vehicle is not allowed to overspeed, let alone overpressure operation, because this will seriously damage the air compressor.

 3 axle 36CBM bulk cement tank semi trailer_4

2. As for the taboo of air compressor use, it is not allowed to start or stop the air compressor quickly, but should increase or slow down slowly, otherwise the air compressor will be damaged by impulse pressure.

 

3. The rotation direction of the air compressor cannot be changed, otherwise, the machine will be seriously damaged if the oil pump does not supply oil.

 

4. Do not stop the air compressor before decompression, otherwise the powder material will flow back to the cylinder and seriously damage the air compressor.

 

5. Check the oil level before starting the machine. The oil level shall not be lower than the lower limit of the oil standard; the oil supply condition of the oil pump shall be checked frequently. If the oil is not supplied, the machine shall be stopped immediately for inspection, because the air compressor will be damaged due to lack of oil.

 

6. The lubricating oil shall be changed regularly. After the new machine is used for 30 hours, the oil in the crankcase shall be discharged, the inside of the crankcase and the oil filter net shall be cleaned, and then the oil shall be changed. After that, the oil shall be changed every year.

3 axle 36CBM bulk cement tank semi trailer_5

7. Do not mix different brands of lubricating oil. Under normal circumstances, it is necessary to check and clean the machine once a quarter. If the utilization rate of the machine is too high, it must be checked and cleaned once a month.

 

8. Maintain and clean the air filter element every 30 hours. When the filter element is rotating, use compressed air with pressure less than 0.6MPa from inside to outside. Replace the filter element after 5 times of maintenance. Do not use oil or water to clean the filter element.

 

Powder material transport vehicle is still widely used in the market. We must pay attention to the above problems when using. Only in this way can we reduce the probability of vehicle problems and extend the service life of vehicles.